Watermark RAYMOR Classic II Rimless P trap Quick Start Manual

RAYMOR
Classic II Rimless P trap
Couple Toilet Suite
Installation set out for Classic ll Rimless Close couple Toilet Suite
Product Code: STD Seat Suite 194380
SET OUT DRAWING
Remove all products from packaging:
Check the product for damage, if the product is damaged return to the store of purchase, Check
the product is complete with all components required to install.
This product is to be installed by a licensed plumber, failing to do so will void warranty. This
product is to be installed as per Australian Standards and local authority requirements.
Warning:
Do not bed the pan in place using cement, concrete OR SIMILAR MARTERIAL, DOING
SO WILL VOID THE PRODUCT WARRANTY.
Toilet Suite Installation
Toilet Pan Installation
N.B The distance from the back edge of the pan to the start of the 'P' trap is 10mm(due to
shrinkage variations please measure the distance on the pan to confirm) taking into account full
engagement of the pan collar on the 'P' trap. Install waste pipe as per Australian standards and
local authority requirements. The distance from the floor to the center of the 'P' trap is 185mm,
set your waste pipe height accordingly.
1. Mark the centre line of the Pan connector on the wall for 'P' trap installation.
2. Place the pan into position centralising the pan on your centre line, draw around the pan base
and mark the entry points on the floor to where the floor fixing holes are on the side of the pan.
3. Remove the pan and drill and screw into place the floor fixing brackets, set the floor fixing
brackets 15mm inside the line drawn around the base. Use suitable floor fixing screws & toggles
to suit the floor material.