Advertisement
Quick Links
Conductive Bracelets!
Conductive Bracelets!
YOU WILL NEED:
Scissors
Sewing
Needles
1
CUT the FELT for your bracelet.
Make it at least 2" or more inches wide. Plan the length
to wrap your wrist with at least 1inch extra overlap.
OUTSIDE of BRACELET
"OUTIE" SNAP
Markings on the Battery Holder & LED indicate Positive (+) & (-) Negative ends. Be sure to arrange as
shown: Positive end of battery holder towards the positive end of LED.
Please visit www.BrownDogGadgets.com for more great ideas & info.
Felt
Regular
Thread
(+)
(-)
BATTERY HOLDER
Conductive
Snaps
Thread
INSIDE of BRACELET
(+)
(-)
LED LIGHT
TIME:
45-90 MINUTES
Battery
1 Battery
1 LED
Holder
"INNIE" SNAP
Advertisement
Summary of Contents for Brown Dog Gadgets Conductive Bracelet
- Page 1 Conductive Bracelets! Conductive Bracelets! TIME: YOU WILL NEED: 45-90 MINUTES Scissors Conductive Snaps Battery 1 Battery Sewing Felt 1 LED Regular Thread Holder Needles Thread CUT the FELT for your bracelet. Make it at least 2" or more inches wide. Plan the length to wrap your wrist with at least 1inch extra overlap.
- Page 2 THREAD the NEEDLE with conductive thread. Tie a knot 3 times in the end of a loop. This will keep it from pulling out of the material. SECURE the “OUTIE” SNAP Pull the needle up through the bottom of the bracelet and then push the needle through a hole on the snap.