Griots Garage 44409 Quick Start Manual

P T T G & F
ROGRAMMABLE ALKING IRE AUGE LASHLIGHT
Thank you for purchasing this fine product from Griot's Garage. Enjoy the best!
FEATURES
1 ⁄ 2
• 5 to 99 PSI in lb units (.4 to 6.9 Bar)
• Talking gauge announces pressure measurement in both English and Spanish
• Allows you to enter and store the recommended pressure levels for your vehicle's
front and rear tires
• Easy-to-read blue backlit LCD
• White LED flashlight
• Included 2- 3Volt CR2032 Lithium batteries (replaceable)
TO MEASURE TIRE PRESSURE WITHOUT PRESET GOAL
Press Mode, all digits light up then "0.0" appears. Default unit of measure is PSI.
Push the nozzle of the gauge onto the tire valve. Make sure a good seal is made between the
nozzle and the valve.
Hold the gauge on the valve stem until a reading is held on the display. You will hear the gauge
talking. Gauge will voice the pressure reading.
Promptly remove gauge from valve stem.
The pressure reading will be displayed for approximately 10 seconds. With the reading displayed
you may press any key to hear the reading again for the last time.
Gauge will reset to 0.0 after 10 seconds from the moment gauge has stopped talking.
Gauge will automatically shut off 10 seconds after displaying 0.0.
PRESETTING PRESSURE GOALS
Press Mode, all digits light up then "0.0" appears.
Press and hold the MODE button for 3 seconds to enter setting mode.
PSI or Bar appears and blinks. Press the up or down to switch between PSI and Bar. Press the
MODE switch to confirm setting.
Language English "EN" for Spanish "SP" appears and blinks. Press the up or down to switch
between EN and SP. Press the MODE switch to confirm setting.
Front or rear tire lights up and blinks. Press the MODE button to confirm setting. Press up or
down buttons to change the pressure goal number. Press the MODE switch to confirm setting
and change tire. Press up or down buttons to change the pressure goal number. Press the MODE
switch to confirm setting.
The unit of measure, language and goal numbers light up in turns and stay for about 2 seconds.
Note: To exit at any stage in setting mode, press and hole the MODE button for 3 seconds.