Subscribe to Our Youtube Channel
Related Manuals for CRL LLPA
Summary of Contents for CRL LLPA
- Page 1 ASSEMBLY INSTRUCTIONS LLPA, LLPUA, DLLPA LOCKING LADDER PULL ASSEMBLY 2503 E. Vernon Avenue, Los Angeles, CA 90058-1826 (800) 421-6144 Fax (800) 262-3299 crlaurence.com ALUMINUM 11M0354...
-
Page 2: Table Of Contents
Ladder Pull Handles. Please store screws and internal mechanisms in a safe place until you are ready to reassemble. Refer to the 11M0189 Locking Ladder Pull Installation Manual to install the reassembled handles onto your door. NOTE: LLPA shown. LLUPA and DLLPA similar TABLE OF CONTENTS ABOUT THIS MANUAL... -
Page 3: Disassemble Handle
CRL LOCKING LADDER PULL ASSEMBLY DISASSEMBLE HANDLE Top Mounting Post Separate Interior and Exterior Handles Remove Set Screws at Interior Top and Bottom Mounting Posts. Remove Interior Handle Lock Housing Screw and separate handles. NOTE: Handle in unlocked position. External... -
Page 4: Disassemble Interior Handle
CRL LOCKING LADDER PULL ASSEMBLY DISASSEMBLE INTERIOR HANDLE Remove Cam and Thumb Turn Remove Cam and Thumb Turn. Remove Bottom Mounting Post, Internal Housing and Transmission Cover Remove Bottom Mounting Post. Remove Strike Pin Sleeve and Internal Housing Remove Screws and Set Screws from Transmission Cover and store in safe place. -
Page 5: Disassemble Exterior Handle
CRL LOCKING LADDER PULL ASSEMBLY DISASSEMBLE EXTERIOR HANDLE Remove Bottom Mounting Post Rubber Remove Bottom Mounting Post. Washer Rubber Washer Metal Washer Exterior Handle Spacers Connecting Grommet Screw Loosen screw to remove Bottom Mounting NOTE: Store Mounting Post Fittings Post Fittings. -
Page 6: Assemble Internal Handle
CRL LOCKING LADDER PULL ASSEMBLY ASSEMBLE INTERNAL HANDLE Gear Base Install Internal Housing Assemble Internal Housing. Fixed Rack Fixed Rack Connecting Rod Rack Rack Gear Base Align Rack teeth and insert Gear from bottom. Gear Connecting Rod Gear Hold Gear in Base and push Internal Housing into bottom of tube. -
Page 7: Test And Adjust Internal Housing
CRL LOCKING LADDER PULL ASSEMBLY ASSEMBLE INTERNAL HANDLE (CONTINUED) Test and Adjust Internal Housing Internal Housing in open Turn Gear 180 degrees to move Strike Pin from position with Strike Pin flush flush to 3/4” (19 mm) past bottom of tube. -
Page 8: Install Thumb Turn
CRL LOCKING LADDER PULL ASSEMBLY ASSEMBLE INTERNAL HANDLE (CONTINUED) Install Thumb Turn Bottom Mounting Post Screw Remove Bottom Mounting Post Screw to slide Transmission Cover onto tube and then reinstall. NOTE: Hold gear from bottom so it doesn’t fall. Transmission... -
Page 9: Secure Internal Housing To Tube
CRL LOCKING LADDER PULL ASSEMBLY ASSEMBLE INTERNAL HANDLE (CONTINUED) Secure Internal Housing to Tube Install Screw at top of Internal Housing. Install Strike Pin Sleeve at bottom tube. Strike Pin Sleeve NOTE: Handle shown from side. Align holes and secure. -
Page 10: Assemble External Handle
CRL LOCKING LADDER PULL ASSEMBLY ASSEMBLE EXTERNAL HANDLE Bottom Tube Install Lock Cylinder Slide Exterior Housing onto tube from bottom and align at cutout. Install Lock Cylinder at exterior and Housing Adaptor at interior. Secure External Housing to tube. NOTE: Handle shown from side.
Need help?
Do you have a question about the LLPA and is the answer not in the manual?
Questions and answers