Table of Contents
Advertisement
Problem
The product does not stop when you
push the stop button.
The product starts but there is no vi-
bration.
The vibrations in the product are not
correct.
The noise level is too high.
The vibrations are not equal along
the concrete surface.
The vibration in the handle is too
high.
Transportation
•
Keep the handles folded during transportation.
12
Cause
The cable for the stop button is bro-
ken.
The vibration damping unit on the vi-
bration shaft is damaged.
The eccentric element is incorrectly
set.
The vibration bearings are damaged.
The handle knobs are not sufficiently
tightened.
The vibration frequency is too low.
Incorrect vibration procedure.
The vibration damping units are
worn.
Transportation, storage and disposal
Solution
Examine the cable and replace it if it
is necessary.
Replace the vibration damping unit
and the bearings on the vibration
shaft.
Adjust the eccentric element. Adjust
50% if there is too much vibration.
Adjust 100% if the vibrations are not
sufficient.
Replace the vibration bearings.
Tighten the handle knobs.
Increase the vibration frequency.
Operate the product correctly. Refer
To operate the product on page
to
10 .
Replace the vibration damping units.
Refer to
for the position of the vibration damp-
ing units.
•
During transportation, keep the engine in a vertical
position to prevent fuel leakage.
•
Safely attach the product during transportation to
prevent damage and accidents.
Storage
•
Clean the product before storage.
•
Keep the product in a dry and frost-free area.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
Product overview on page 2
1294 - 004 - 01.12.2021
Advertisement
Table of Contents
