Avvilo G161818 Instruction Sheet

Solar garden stake fairy

Advertisement

FIRST TIME USE : Remove the protective film from the solar panel before the first use.

CHARGING AND OPERATION:

STEP 1. Charge the solar light by placing it under direct sunlight for at least 8 hours.
STEP 2. Turn the switch to "ON" position and the solar light will automatically charge under direct sunlight
during the day time and illuminate at night.
NOTE: In order to verify that the switch is correctly in the "ON" position, cover the solar panel with your
hand and light will turn "ON" automatically.

IMPORTANT:

1. Install the solar light in an area where it can get direct sunlight.
2. Leave the switch to "ON" position..
3. Select an outdoor location away from other light source at night such as street lights. It may cause
the product not to turn on automatically at night.
4. Duration of light depends on solar product's level of sunshine exposure, geographical locations,
weather conditions and the hours of daylight.

MAINTENANCE, TROUBLE SHOOTING AND BATTERY REPLACEMENT

1. Keep the solar panel clean.
2. If solar product does not light up after it has been used for around 8-12 months, replace the
rechargeable batteries as they may be weak or worn out. (Battery 1 Pc "AA" 1.2v 600Mah,
Ni-CD or same equivalent type as recommended must be used).
3. Exercise caution when replacing batteries. Open the battery compartment carefully using a
Solar Garden Stake Fairy
Battery included.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the G161818 and is the answer not in the manual?

Questions and answers

Summary of Contents for Avvilo G161818

  • Page 1 Solar Garden Stake Fairy FIRST TIME USE : Remove the protective film from the solar panel before the first use. CHARGING AND OPERATION: STEP 1. Charge the solar light by placing it under direct sunlight for at least 8 hours. STEP 2.
  • Page 2 small Phillips head screwdriver (Not Included). Be sure to place the battery to it’s correct polarity. CAUTION: Do not pull the lid all the way or wiring may break. Be careful not to damage the circuit board or wiring. Close the lid back with the screws and make sure it is properly sealed.

Table of Contents