Table of Contents
Advertisement
2
Inserting the batteries into the remote
Remove the back cover to reveal the battery compartment. Insert two size AAA batteries. Make sure the (+)
and (-) signs match (observe correct polarity). Do not mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. A message will be displayed on the screen when the batteries are
low and must be replaced.
3
Connections
Antenna
Connect the antenna cable/s to your TV.
rear side of the TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
Plug the power cable to the mains socket whilst in 'off' position, and then turn the mains
socket on.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
4
Switching on the TV
In order to turn the TV on from standby mode:
• Press the Standby button, a numeric button or
Programme +/- button on the remote control
• Press the centre of the control switch inwards,
located at the rear left hand side of the TV
satellite
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the centre of the
control switch inwards consecutively until the Sources
list is displayed.
HDMI connection
rear of TV
English - 2 -
Advertisement
Table of Contents
