Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Newport Vessels DANA
- Page 1 Owner’s Manual and Safety Instructions www.newportvessels.com...
- Page 2 This full owner’s manual can be downloaded from the Newport website (www.newportvessels.com). In addition, we invite you to visit the Newport Vessels Video Library and FAQ’s. We have put together an extensive collection of short video tutorials as well as answers to FAQ’s.
-
Page 3: Table Of Contents
Contents 1. Boat Models & Specs ................3 2. Conformity Declarations ...............3 Assembly ..................4 3. Assembly and Disassembly ..............4 Floor Assembly ..................5 Side Joiner Assembly .................5 Air Floor Assembly ................6 Disassembly ..................6 Cleaning Procedures ................6 4. Operation information .................6 Safety ....................6 Aspects of Environment Protection ............7 Inflation - Deflation ................7 Loading ....................7... -
Page 4: Boat Models & Specs
1. Boat Models & Specs DANA DEL MAR NEWPORT BAJA CATALINA WOOD FLOOR INFLATED INFLATED MODELS LENGTH WIDTH CHAMBERS WEIGHT POWER MAX LOAD PERSONS DANA 8’10” 5’ 3 + 1 107 lbs 10 HP 1067 lbs DEL MAR 9’6” 5’... -
Page 5: Assembly
3. Assembly and Disassembly Assembly LAYOUT ON FLAT ATTACH PUMP TO SMOOTH SURFACE VALVES • When using the boat for the first time, fully • Remove any sharp object from flat surface inflate it by attaching the foot pump to each where the boat will be assembled and of the tube chamber valves, one at a time, inflated. -
Page 6: Floor Assembly
Floor Assembly IDENTIFY AND IDENTIFY AND SNAP DOWN INTO LAYOUT BOARDS LAYOUT BOARDS PLACE NOTE: Identifying number on floor boards must face upwards. • Insert floor board No. 2 into floor boat No 1. • Identify numbers on the floor boards and lay them out flat on the ground. -
Page 7: Air Floor Assembly
4. Finish inflating the air chambers one after the INSTALL SEAT other in order to maintain equal amount of air. DO NOT inflate any chamber to full capacity at the one time. Install valve caps. 5. Inflate the keel and attach valve caps Disassembly NOTE: The boat should be clean and dry before rolling up for storage. -
Page 8: Aspects Of Environment Protection
being operated, and the size, speed, course, 12. On extended voyages due consideration kind of boat (power, oars, etc.) and mode of must be given to safety equipment such as operation. flares, first aid kit, anchors, etc. In addition to knowing and following the Aspects of Environment applicable laws, please note the following: Protection... -
Page 9: Operation: Outboard Motor
the towing boat. The bow ring should only be a rowing –seat as standard. Ensure seat is properly installed. used to attach a mooring line. 2. Install oars in thole-pins, attach thole-pin cap Air Chamber Failure screws. 1. Should an air chamber get punctured, shift the NOTE: DO NOT use oars as levers: they could weight to the opposite side. -
Page 10: Repair Procedure
Designation of the boat: Inflatable Boat a mountain lake), the air pressure must be reduced at the higher altitude to prevent over Boat Type: The Dana, The Del Mar, The Newport, The Baja, The Catalina, The inflation. Seascape, The Santa Cruz. -
Page 11: Safety Instructions
7. SAFETY INSTRUCTIONS: When boating: learn and respect local regulations and practices. Do not neglect the safety rules, this could jeopardize your life and the lives of others. CAUTION! DO NOT EXCEED AUTHORIZED NUMBER OF PERSONS OR WEIGHT. NO ALCOHOL / DRUGS: Do not drink alcohol or take drugs before or while operating your boat. - Page 12 Email: sales@newportvessels.com Toll-free: (866) 721-0002...