Related Manuals for Fitness Technology 400 Series
Summary of Contents for Fitness Technology 400 Series
- Page 1 FORCE PLATE 400 Series Performance Force Plate Fitness Technology 21 Bishop St. Skye SA 5072 Australia +61 8 8331 9229 Mob: 0418 815 400 www.fittech.com.au Copyright: Fitness Technology, Adelaide, Australia 21 March 2005...
- Page 2 USB Cable plug into your Computer. 14. With the 400S no other power supply or charging of batteries is required. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
-
Page 3: Installation
Should this happen make sure the communication cables are properly installed. If communication failure continues, then replace the USB cable. For any other problems contact our office for further instructions. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400. - Page 4 USB Connector Lead to RJ45 Connector to External RJ45 Socket for LPT cable connection Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400. www.fittech.com.au Copyright: Fitness Technology, Adelaide, Australia 21 March 2005.
- Page 5 4 x feet threads thru all the way - back off 5mm. Refer Trouble shooting Note 5 on Page 7. The Platform M12 Spacer should also always be level when in use. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400. www.fittech.com.au Copyright: Fitness Technology, Adelaide, Australia 21 March 2005.
- Page 6 Do not place or allow any water to ingress into the Platform via the load cell holes or the penetration used for the USB communication port underneath the Platform. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
- Page 7 Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
- Page 8 Data button put a know Mass on the Plate & it should read the correct value of the Mass. Within 0.1 Kg is a typical acceptable Mass reading, Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
- Page 9 Allow a period of 15 seconds to pass before pressing the “Start Continuous Data Transfer” Key. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
- Page 10 ERROR CHECKING” checkbox then press the “Start Continuous Data Transfer” button. Note, with a tick the checkbox the caption changes to “DIAGNOSTIC”. Now you should see one or more channels reading zero. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
- Page 11 XPV7 circuit board. If these numbers don’t match then contact our repair centre for further instructions on resetting these values. Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia Tel: +61 8 8331 9229 Mob: 0418 815 400.
Need help?
Do you have a question about the 400 Series and is the answer not in the manual?
Questions and answers