Download Print this page

Aegis 23PME Manual Sheet

23PME Manual Sheet

Note: Factory Pass Code is 12345678

OPENING THE SAFE FOR THE FIRST TIME

1. Remove the Back-up key cover away.

2. Insert the Back-up key into the keyhole and turn anticlockwise, hole

the position, at the same time, turn the handle

Warning: Do not store your back up keys inside the safe.

With the door unlocked, press the reset button (the red button on hinge

side) and the buzzer beeps twice and yellow light flashes twice. Then

yellow light on.

Input 1 to 8 digits and end with "#" button to confirm the setting.

The buzzer beeps twice and green light flashes twice, it means new code

was successful.

If the buzzer beeps five (5) times and yellow light flashes five (5) times

and yellow light goes on, the code failed. Press reset button again and

Table of Contents

Do you have a question about the 23PME and is the answer not in the manual?

Page 1 23PME Manual Sheet Note: Factory Pass Code is 12345678 OPENING THE SAFE FOR THE FIRST TIME 1. Remove the Back-up key cover away. 2. Insert the Back-up key into the keyhole and turn anticlockwise, hole the position, at the same time, turn the handle Warning: Do not store your back up keys inside the safe.
Page 2 repeat code programming sequence. NOTE: The code can be 1 to 8 digits. TURNING KEYPAD SOUND OFF/ON WITH MUTE-SYSTEM You can mute/unmute the keypad by entering the “*”button with 1 yellow light flash. NOTE: In the factory settings, the sound has been turned on. HOW TO OPEN THE DOOR Input the passcode and end with “#”...
Page 3 SAFE WITH ALARM SYSTEM If 3 incorrect passcode entries are made in succession, the alarm will sound for 50 seconds. Before inputting any code, pressing “3” for 3 seconds, it beeps twice with yellow light flashes, it will active the vibration alarm. It will sound for 50 seconds once safe is impacted or moved.