Inserting Batteries Into The Remote - Sony Bravia KDL-40ZX1 Operating Instructions Manual

Install a wood screw (4 mm in diameter, not
1
supplied) in the TV stand.
Install a machine screw (M6 × 12-15, not
2
supplied) into the screw hole of the monitor.
Tie the wood screw and the machine screw
3
with a strong cord.
5: Performing the initial set-
up

Inserting batteries into the remote

Push and lift the cover to open.
~
• Observe the correct polarity when inserting
batteries.
• Do not use different types of batteries together or
mix old and new batteries.
• Dispose of batteries in an environmentally
friendly way. Certain regions may regulate the
disposal of batteries. Please consult your local
authority.
• Handle the remote with care. Do not drop or step
on it, or spill liquid of any kind onto it.
• Do not place the remote in a location near a heat
source, a place subject to direct sunlight, or a
damp room.
Establishing the wireless
communication between the unit
~
• This unit can be placed in the same room.
• Keep about 30 cm to 20 m distance between the
monitor and media receiver when installing.
• Keep clear the area between the monitor and
media receiver. Otherwise the picture may
deteriorate.
• Rearrange the installation position of the monitor
and media receiver in case of fuzzy picture.
• Do not place either unit on a metallic rack.
• Do not use two units or more at the same time in
an area of radio interference.
1
Press 1 to turn on the unit power.
Media receiver
POWER button
9
(Continued)
GB