Nienkamper VOX Installation Manual

VOX FOLDING CONFERENCE TABLE
INSTALLATION GUIDE
TOOLS REQUIRED:
#4 Hex Key
Philips Screwdriver
Warning:
Components are sprung and under considerable tension.
To avoid potential injury, always pay close attention during use and installation to the presence of all moving parts.
Nienkamper is not responsible for any damages to property or personal injury due to improper use and or installation.
With the help of another person, carefully open the frame and
insert blocking pin. This locks the frame into an open position and
is critical to safe assembly.
Assemble lock latch by aligning bottom housings, center pin, lock-
ing pin, lock throw, latch and top housing as shown. Fix housings
to top with #8 x 1" wood screws. Repeat both sides.
Customer Support: 1.800.668.9318
Email: mail@nienkamper.com
Web: www.nienkamper.com
HARDWARE:
M6 X 25mm
Button Head
x 12
Washer
x 12
THIS IS A GENERAL ASSEMBLY GUIDE, NOT ALL CONDITION MAY APPLY TO YOUR PARTICULAR INSTALLATION
#8 x 1"
Wood Screw
x 24
#6 x 3/8"
Wood Screw
x 4
Place top sections face down on a protective surface, align through
holes in frame with threaded inserts in top. Secure with M6 button
head screws and washers. Note, slight movement of top and frame
is required for anti-pinch feature. Install plastic cover & fi x with #6 x
3/8" wood screw.
Apply the instruction / operation decal.
PAGE 1 OF 2
SUGGESTED MINIMUM CREW:
APPROXIMATE INSTALL TIME:
Plastic Cover
x 4
Lock Latch
x 2
2
30 min.
Operation
Decal
x 1
Blocking Pin
x 1