Introduction The Harol OB450 is a built-on shutter to be mounted on top of the window frame. Generally one provi- des the space for this shutter when constructing the building so that the shutter can be fitted at a later stage.
Page 3
• Use some tape to keep the curtain inside the box. • At the bottom side of the OB450-box there is an adhesive strip. Take off the protective film of this strip (zie fig 2). • The standard frame brackets must be fastened to the heads of the box by using screws (fig3).
Page 4
Assembly instructions built-on shutter OB450 Figure 5 Figure 6 • Remove the protective film of the adhesive bar for fixation. Mount the adhesive bar for fixation and press firmly. Figure 7 Figure 8 • Now the whole - the window and the built-on roller shutter – is to be placed and mounted into the opening.
Assembly instructions built-on shutter OB450 E. Operation Tape: Example fitting of a wall mounted tape coiler: Figure 11 Crank handle operation: 1) non-detachable rod :slide the foldable crank handle over the round part of the cardan joint and use the splitpen to connect the two items. Slide the security over the splitpen. Mark the place of the clamp on the window profile or the wall and fix it.
Page 6
(included) of the chosen type of motor. G. Guarantee and conditions • Harol has endeavered to design and assemble this roller shutter in accordance with the ruling and valid CE-norms. Nevertheless, feel free at any time to countercheck these interpretations with your local national institute of normation.