Philips 40PFL3505D/F7 Service Manual page 20

Note:
(1) Order of steps in procedure. When reassembling,
follow the steps in reverse order. These numbers
are also used as the Identification (location) No. of
parts in figures.
(2) Parts to be removed or installed.
(3) Fig. No. showing procedure of part location
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
H = Hex Screw, CN = Connector
e.g. 2(S-2) = two Screws of (S-2),
2(L-2) = two Locking Tabs of (L-2)
(5) Refer to the following "Reference Notes in the
Table."
(S-2)
[1] Stand Assembly
4-8
[2] Rear Cabinet
(S-2)
(S-1)
(S-2)
(S-2)
(S-3)
(S-2)
(S-2)
Fig. D1
A01PCDC