Important Safeguards • Do not plug this unit into an extension lead, double adapter or power board. When using this electrical appliance, • To disconnect the unit set main switch to OFF then remove the plug from the power outlet. the following basic safety precautions should always be followed: •...
Page 3
Warning If the supply power cord is damaged, the power cord must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. This product has not been designed for any uses other than those specified in this booklet. Save These Instructions...
Page 4
Appliance Construction Diagram Attention The illustrations shown within this manual are for reference only and may not accurately present the physical product contained inside product packaging. Component name Air outlet grille Display screen Operation Control panel Air inlet grille Pre-Filter HEPA Filter...
Page 5
Assembly Instructions Note: Before first use you must remove the protective film that envelopes the HEPA filter. Take out Pre-Filter Disassembly/Assembly Press down locking tabs with your two thumbs to unlock, tilt forward and lift to remove the Pre-Filter Remove the air inlet grille Remove the HEPA Filter Remove the protective film enveloping the Tilt filter forward and with hand on each...
Page 6
Operating Instructions Control panel Sleep Mode With PM2.5>than 50 Micro Grams/ Cubic Meter Automatically increases Light Sensor Automatic Mode fan speed to ensure efficient Fan Speed Selection Adjusts fan speed function purification effect. With Micro Grams/ Button automatically Cubic Meter <than 50 PPM Low, Medium or High according to air quality.
Page 7
First Time Operation Attention • Incorporated within this appliance is a disabling protection, the appliance cannot be operated unless air inlet/outlet grilles are fitted correctly. • With uninterrupted power supply you can only engage Standby by first selecting an operation mode or each time the appliance itself is switched ON.
Cleaning and Maintenance Appliance cleaning Attention When conducting any maintenance or cleaning activities on the appliance you must disconnect the appliance from the power supply. Host Wipe the external surfaces of the appliance down with a damp soft towel, do not use abrasive, chemical cleaning detergents, mild detergent is fine Air inlet grille Remove air inlet grille and clean internal surface of both grille and filter compartment with soft brush,...
Page 9
Cleaning of the Pre-Filter It is recommended that the Pre-Filter gets cleaned regularly, once every two weeks. It may require for this to be conducted earlier where it is evident that dust deposits on the Pre-Filter obstruct the airflow, so please check regularly and clean if needed to ensure optimum performance.
Replacement of the filter components When the filter replacement indicator light Filter model: illuminates, it reminds the user that the HEPA Filter FC-35S1A (1 Filter should be replaced. included with the If filter is not replaced, the indicator light will appliance) continue to illuminate each time you start up the appliance.
Page 11
(AUSTRALIA) OR 0800 764 912 (NEW ZEALAND) GSM RETAIL AUSTRALIA PTY LTD The GSM Retail Australia Pty Ltd Group Companies has a policy of continual improvement throughout the product range. As such the unit contained within may differ slightly from the unit illustrated on the pack.
Need help?
Do you have a question about the Mistralaire MAP350G and is the answer not in the manual?
Questions and answers