Loading Door Lock - Beko WTK74151W User Manual

programme flow while the programme is running.
To do this, the change you are going to make
must be something that will be carried out after
the programme step that is running. If the change
is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the
spinning step, the Rinse Hold function
might be active or the automatic
unbalanced load detection system might be
activated due to the unbalanced distribution
of the laundry in the machine.

4.3.14 Loading door lock

There is a locking system on the loading door of
the machine that prevents opening of the loading
door in cases when the water level is unsuitable.
Loading door light will start flashing when the
machine is switched to Pause mode. The machine
checks the level of the water inside. If the level is
suitable, the loading door light will turn off and the
loading door can be opened within 1-2 minutes.
If the level is unsuitable, the loading door light
will remain on and the loading door cannot be
opened. If you are obliged to open the loading
door while the Loading Door light is on, you
must cancel the current programme. See
"Cancelling the programme"
Opening the loading door in case of power
failure:
C
INFORMATION
• In case of a power failure, you can use the
loading door emergency handle under the
pump filter lid to manually open the loading
door.
A
WARNING!
• Before opening the loading door, make sure
that there is no water in the machine to
avoid flooding. Water may be hot and could
cause scalding.
22 / EN
• Open the pump filter lid.
• Release the loading door emergency
handle at the back of the filter lid.
• Pull down the loading door emergency
handle to open the loading door. After
opening the door, return the emergency
handle to its original position.
• If you cannot open the loading door,
try pulling down the handle again.
4.3.15 Changing the selections
after programme has started
Switching the machine to pause mode
Press the Start/Pause to switch the machine
to pause mode while a programme is running.
The light of the current programme will flash on
the Programme Follow-up indicator, indicating
that the machine has switched to pause mode.
Also, when the loading door is ready to be
opened, the Loading Door light will turn off in
addition to the programme step light.
Washing Machine / User's Manual