Witt VBreathe Tasman Getting Started

Witt VBreathe Tasman Getting Started

Advertisement

Quick Links

Setting up VBreathe Tasman

Cap
Power Button
Base
1. Unscrew the cap of VBreathe Tasman. Remove
the lid and seal from the VActive Gel cartridge.
Place the Gel cartridge into Tasman open end
facing up and screw the cap back onto the device.
(See Replace VActive Gel instructions)
2. Download the VBreathe App from the
App Store or Google Play Store.
3. Plug in the power adaptor, then plug
the USB C cable into the back of your
VBreathe Tasman to power.
4. Double press the power button on the front of your
VBreathe Tasman to activate Bluetooth pairing.
5. When prompted by the VBreathe App, enter
the 8-digit pin on the back of these instructions.
Notice: This feature is not available yet.
On
Standby
Auto Mode
Recharging
Battery Full
Getting Started

Device Status

Gel
Unscrew cap to
insert VActive
Gel cartridge
Charging Port
On back
Solid White
Slow Pulsing White
Fast Pulsing White
Solid Red
Pulsing Red
Solid Green

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VBreathe Tasman and is the answer not in the manual?

Questions and answers

Susan Stack
May 12, 2025

how do I know if the battery in my Tasman needs replacing, I am unable to get the app to work - SN VBTAS-SL011882, thank you

1 comments:
Mr. Anderson
May 20, 2025

The battery in the Witt VBreathe Tasman should be replaced by VBreathe or an authorised service provider. There are no specific indicators mentioned for when the battery needs replacing, but do not attempt to disassemble the product or remove the battery yourself. If you notice significantly reduced battery life or charging issues, contact VBreathe for service.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Witt VBreathe Tasman

  • Page 1 Power Button HEPA Filter Base 1. Unscrew the cap of VBreathe Tasman. Remove the lid and seal from the VActive Gel cartridge. Place the Gel cartridge into Tasman open end facing up and screw the cap back onto the device.
  • Page 2 Turn Off – Press and hold for 3 seconds When the device switches off completely, it will no longer be connected to the App. Factory reset – Press and hold for 10 seconds Device restores factory settings. VBreathe Tasman will be inactive for 10 seconds during Factory Reset.
  • Page 3 Replace VActive Gel Important: Never turn your device upside down while it has a VActive Gel cartridge installed. 1. Ensure the device is upright, turned off and unplugged. Unscrew the top cap of the VBreathe Tasman as shown in the diagram and remove the used VActive Gel cartridge.
  • Page 4 Should you experience any sensitive or allergic reactions to the vapour emitted from VBreathe Tasman then discontinue use immediately. Use of the VBreathe Tasman device in high temperature or humidity may use the gel quicker than indicated. Battery & Disposal Information This device contains a Lithium Polymer (LiPo) battery and should be replaced by VBreathe or an authorised service provider.

Table of Contents

Save PDF