Table of Contents
Advertisement
Troubleshooting
Remote Control
Battery poles (+) (–) are reversed.
aInsert the battery correctly.
Wrong battery.
aCheck the battery.
Battery has run down.
Buttons are invalid for
aReplace the battery.
operation.
23
Remote control is in the wrong direction.
aDirect the remote control at remote control sensor on the display unit.
Direct sunlight disturbs the transmission of remote control.
aMove your car to prevent the car from being exposed to direct sunlight, or
install the remote control sensor on another place to keep it out of direct
sunlight.
Sound Settings
No sound from left,
Cables are not correctly connected.
right, front, or rear
aConnect the cables correctly.
speaker.
Left and right sounds
The speaker leads are connected in reverse between right and left.
aConnect the speaker wires to the correct one.
are reversed.
Display Setting
The display screen is
The video format of the DVD changer does not correspond to the video format
not stable and/or col-
of the monitor display.
aMake the video format of the DVD changer correspond to the video for-
ored, or rotates
mat of the monitor display.
improperly.
50
CX-DH801U
(Continued)
Error Display Messages
DVD Changer (Control unit / Monitor display)
Problem
- E 1 -
Disc is dirty, or is upside down.
(Control unit display)
aCheck the disc.
(Next disc will be selected
automatically after 5 seconds.)
- E 2 -
Disc has scratches.
(Control unit display)
aCheck the disc.
(Next disc will be selected
automatically after 5 seconds.)
- E 3 -
No operation by some cause.
aOnce turn the ACC switch off, and turn it on again. And, push the reset
(Control unit display)
switch
(a
(Next disc will be selected
chased the unit or the nearest Panasonic Servicenter.
automatically after 5 seconds.)
- E 6 -
An attempt was made to play a disc with a region number other than "1" or
(Control unit display)
"ALL". Or, the unknown error related with discs occurs.
(REGION ERROR etc.)
aCheck the disc.
(Next disc will be selected
automatically after 5 seconds.)
No disc is in the changer.
NO DISC
aInsert disc into the disc tray.
No magazine is in the changer.
NO MAGAZINE
aLoad the changer with disc-loaded magazine.
Note: There may be cases when the disc numbers affected by an error are displayed before E1 and E2.
Possible cause
Possible solution
a
page 53). If these operations fail, call the store where you pur-
CX-DH801U
24
51
Advertisement
Table of Contents
