AEG FAVORIT 60860 User Information page 9

Setting electronically:
1. Press the ON/OFF button.
3
If the LED indicator of only one programme button is illuminated, this
wash programme has been activated. The wash programme must be
deselected:
Press function buttons 1 and 2 simultaneously for approx. 2 seconds.
The LED indicators of all the programme buttons that can be selected
will illuminate.
2. Press function buttons 1 and 2 simultaneously and hold them down.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1.
The LED indicator for function button 1 will flash.
The multi-display will indicate the hardness setting.
4. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to "1", this switches off the
control indicator for dishwasher salt.
Water hardness
1)
in °d
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
below 4
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
2)
in mmol/l Range
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5 IV
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
III
2,6 - 3,2
1,9 - 2,5 II
0,7 - 1,8 I/II
below 0.7 I
Adjusting the hardness
setting
Manual Electronic
3)
10
9
1 8
7
6
5
4*
3
0*
2
1
no salt
necessary
Indication on
the multi-dis-
play
10L
.
9L
8L
7L
6L
5L
4L
3L
2L
1L
9