Before First Use - Single Axle and Twin Axle Modes Page 7 Before First Use - Pairing the Handset and Control Unit(s) Page 7 Using Your Caravan Mover with Quattro® Technology Page 8 Operation - Getting Started Page 8 Maintenance...
Introduction Thank you for choosing an Ego® caravan mover. This has been produced according to very high standards and has undergone careful quality control procedures. Simply by using the remote control you can move your caravan effortlessly into any position required within operating guidelines. Before proceeding with installation and starting to use the mover, please read this manual very carefully and be aware of all the safety instructions! The owner of the caravan will always be responsible for correct use.
Page 6
‘A’ frame. Please refer to table B (below) for fitment of the motor units to the REAR of the axle. Note: If you are fitting two sets of motors onto a twin-axle caravan to form a full Quattro® system then both Table A &...
Operation - Safety Guidelines Before use, always check the mover for any damage. When towing or moving the caravan please be aware, at all times, that ground clearance is reduced by 50mm when the Mover has been fitted. To maintain signal strength, always make sure that, during manoeuvring, the distance between the remote control and the caravan does not exceed 5 metres.
Before First Use - Single Axle and Twin Axle Modes The following procedure depends on whether you are using the Quattro® electronics for a single axle or twin axle caravan: To enable Single-Axle Mode: Install only 2 of the 3 ‘AAA’ batteries into the battery compartment of the handset (Fig.5).
Also, the amount of different manoeuvres required to locate/park your caravan is increased. However, the advanced electronics of the Quattro® electronics take care of the manoeuvring whilst also taking care of your caravan.
Trouble Shooting Should your mover fail to operate, please check the following: Unit fails to operate, does not function at all: Make sure that the Battery Power Isolation Switch is turned on. Is the Remote Control Handset ‘paired’ with the Control Unit? To ‘pair’ the Handset and Control Unit please follow the procedure detailed in the section ‘Before First Use - Pairing the Handset &...
Page 11
Trouble Shooting Rollers slip on wheels: Check that the distance of the rollers to the tyres is 20mm on both sides. Check for correct tyre pressure by referring to your caravan mnaufacturer’s handbook. If the pressure is low, the roller would need to be pushed into the tyre further than usual to gain sufficient traction.