Skyvue C-OBX-6573-P Owner's Manual page 20

Connecting to a DVD/Blu-ray Player
Connecting with HDMI Cable (Best Option)
1. Make sure the power of the TV and your DVD/Blu-ray player is
turned off.
2. Connect a HDMI cable to the HDMI port of your DVD/Blu-ray player
and the other end to the HDMI port off the back of your TV.
3. Turn on the TV and your DVD/Blu-ray player.
4. Use the remote control's input button or the input button on the TV to
switch to HDMI.
Please Note :
1. Refer to the DVD/Blu-ray player's manual to make sure the DVD/Blu-ray player is
configured to output correctly to the TV.
2. This TV does not decode Bit stream digital audio, so make sure the
DVD/Blu-ray is setup for PCM digital audio through HDMI.
3. If HDMI 1 is occupied, use HDMI 3 as your connection port.
Connecting with Component
1. Make sure the power of TV and your DVD/Blu-
ray player is turned off.
2. With a Component Cable, connect the green
connector to the DVD/Blu-ray player and
Component green connector port on the TV.
3. Connect the blue color connector to your DVD/
Blu-ray player and Component blue connector
port on the TV.
4. Connect the red color connector to both your
DVD/Blu-ray player and Component red
connector port on the TV.
5. With an RCA Audio Cable, connect the white
color connector to both your DVD/Blu-ray
player and Component white connector port
on the TV.
6. Connect the red color connector to both your DVD/Blu-ray player and
7. Component red connector port on the TV.
8. Turn on the TV and your DVD/Blu-ray player. Use the remote control's input button or the input button on the
TV to switch to YPbPr.
Please Note :
1. Refer to the DVD/Blu-ray player's manual to make sure the DVD/Blu-ray player is configured to output correctly to the TV.
2. This TV will turn off automatically if there's no signal present for more than 15 minutes.
18
DVD/Blu-ray
Located on Back of TV
DVD/Blu-ray
Located on Back of TV
All Rights Reserved. SkyVue
®