Advertisement
Tips & Tricks for using
your new Wine Cooler
Q U I C K S T A R T G U I D E : H B R W C 3 4 B
Installation & First Use
Before installing your new Wine Cooler, please read
all safety instructions in the user manual.
Place the wine cooler on a sturdy, level floor for quiet
operation. If it is to be placed on carpet, support it
with a wooden board underneath. This appliance is
designed to be freestanding only and should not be
recessed or built in.
Before turning on your wine cooler for the first time:
° The wine cooler must be rested for at least half
an hour before connecting power.
° Clean the inner chamber with lukewarm water
and a soft cloth.
° Do not connect cooler to electronic energy saving
plug and converter that can convert DC into AC
(E.g.: solar energy system. ship grid).
° Condensation or frost will form on the rear of
wine cooler when the compressor is running.
This is a normal function of cooler. Wiping away
the frost or condensation is not required as it will
eventually evaporate. The defrosted water will
be collected into a drain tank and then flow into
a water disposal pan above the compressor
before evaporating.
° This wine cooler has a power off memory
function. If the unit is powered off, the cooler will
run according to previous the setting before the
power off.
Support: 1300 11 43 57
Operating the Wine Cooler
You can set and adjust the temperature in the
cabinet to anywhere within the cooling range
(5° C – 18° C) using the UP and DOWN buttons on
the Control Panel to set the desired setting.
Press and hold the Lock button for 3 seconds to
Unlock and Lock the Control Panel.
The light button will switch the interior light
On and OFF.
Press and hold both UP and DOWN buttons
simultaneously to switch between displaying the
temperature in Fahrenheit or Celsius.
For more tips on operating your wine cooler,
please see page 10 of your User Manual.
W W W. H A R B O U R-A P P L I A N C E S .C O M . AU
Version: 1.0
Advertisement
