Canon EOS-1D Mark II Digial Instruction Manual page 150

C.Fn-09
You can change the AEB sequence when you bracket with the shutter
speed, aperture, or ISO speed. You can also change the white balance
bracketing sequence.
When "Auto cancellation" is set, bracketing will be canceled after you
change the lens or turn the <
1: The first bracketed shot is the standard exposure (or exposed with
the standard white balance). This bracketing sequence can be
repeated.
2: Starts the bracketing sequence with the decreased level.
3: Repeats the bracketing sequence starting with the decreased
level.
C.Fn-10
1: The AF point does not light at all. Effective when it is bothersome
to see it light up.
2: Prevents the dimmed lighting of C.Fn-10-0.
3: Effective when the AF point lighting is difficult to see with C.Fn-10-0.
C.Fn-11
1: This reverses the functions of the <
¡
2: While exposure metering is active, turn the <
horizontal AF point. (If C.Fn-13-3 has been set, select a
peripheral AF point.) This is also possible while you press the
shutter button halfway and during continuous shooting with AI
Servo AF. The AF point selection stops at the extreme left,
extreme right, top-most, and bottom-most AF points.
¡
During autofocusing, you can press the <
instantly to the automatic AF point selection mode.
¡
You can also select the AF point (including automatic AF point
selection) with the same operation as C.Fn-11-1.
¡
If both C.Fn-11-2 and C.Fn-18-1/2 (p.153) have been set, select
a vertical AF point by pressing the <
5
< > dial.
3: This reverses the functions of the <
150
Auto bracketing sequence / Auto cancel
4
> switch to <
AF point illumination
AF point selection method
2
>.
S
> button and <
5
> dial to select a
S
> button to switch
O
> button and turning the
S
> button and <
O
> button.
I
> button.