Power Management; Auto Reconnect - Monster PUSAT BUSINESS PRO STEEL KEYBOARD User Manual

EN
Pairing
1. Turn on the keyboard
2. Press Fn+
model for Channel BT1.
3. Press and hold BT1 for 5 seconds, wait until you see the BT1 blue light flashes.
4. Turn on bluetooth of your Mac to automatically search for remote devices.
5. Tap" PUSAT B.PRO.KB' to start pairing.
6. Once the pairing is completed, the blue LED light will stop flashing (It works same for
BT2)
7. You can switch Bluetooth Channels by pressing Fn+ BT1/BT2, after paired.

Power Management

Power Saving Mode
The keyboard will automatically go to sleep when not in use for 15 Minutes, press any
button and wait 3 seconds to reactivate it.
Auto-Reconnect
If you turn off the keyboard and turn it back on, the keyboard will be automatically con-
nected to device it paired last time, which means if you use BT1 and connect to device 1
before you turn it off, it will attempt to reconnect to device 1 though channel BT1 after you
turn it on.
Charging
1. Use the included USB-C cable for charging, connect one end to a USB-C adapter and the
other to the keyboard (USB-C adapter is not included)
2. During the charging process, the power switch indicator will turn red, when the
electricity is full, the light goes off. Generally.It takes approximately 9 hours for a full
charge.
Noted: You can use the keyboard while it is being charged, but we don't suggest
such operation, as this may damage the built-in battery to a certain extent.
04
to enter pairing mode, Fox example, press Fn + BT 1 to entry pairing