VideoComm Technologies TC-916 Manual

900mhz desk top transmitter

Advertisement

Quick Links

It's About Real-Time

PARTS LIST

The product has been carefully manufactured, tested, inspected and packaged. Please inspect the packaging carefully to ensure
you have received all the necessary parts and accessories listed. If any parts are missing or damaged, contact Customer Service
or your re-seller immediately.
PARTS
916MHz Desk Top Transmitter
12VDC Power Supply - # PS-1250
3dBi Rubber Duck Antennas - RUB-900
SAFTEY WARNINGS
This is NOT an intrinsically safe device. Do not take into area where intrinsic safety is required. Bodily harm may
result if warning is ignored.
DO NOT OPERATE TRANSMITTER WITHOUT ANTENNA CONNECTED TO ANTENNA PORT. Failure to do
so will result in damage to the unit and void the warranty.
DO NOT OPERATE THE SYSTEM WHEN the Transmitter & Receiver are closer than ten feet to each other. The
devices may not work properly and permanent damage can occur.
900MHz Desk Top Transmitter
TC-916
One
One
One
TC-916hp
TC-916sp
One
One
One
One
One
One
1
900MHz TC-916 Rev-E 04-2007
(888) 379-2666 US Toll Free
(905) 339-0366 Phone
(905) 339-1776 Fax
http://www.VideoTransmitters.com/

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TC-916 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for VideoComm Technologies TC-916

  • Page 1 900MHz TC-916 Rev-E 04-2007 (888) 379-2666 US Toll Free (905) 339-0366 Phone (905) 339-1776 Fax It’s About Real-Time http://www.VideoTransmitters.com/ 900MHz Desk Top Transmitter PARTS LIST The product has been carefully manufactured, tested, inspected and packaged. Please inspect the packaging carefully to ensure you have received all the necessary parts and accessories listed.
  • Page 2 900MHz TC-916 Rev-E 04-2007 SYSTEM SETUP With so many technical variables in an installation, the strongest recommendation we can make is to conduct a bench test. After verifying that all components of the system are in good working order and connected properly, we can arrive on the job site confident that all of our devices will install with the least amount of on site effort.
  • Page 3 900MHz TC-916 Rev-E 04-2007 TIPS & TROUBLE SHOOTING Things that block transmission Things that block transmission are not always obvious. Consider any obstruction that may get in the way or reduce the wireless signal strength along the way. Here are some of the most common pitfalls: •...
  • Page 4 In order to comply with the FCC/IC adopted RF exposure requirements, this transmission system will be installed by an authorized professional installer of VideoComm Technologies. Installation of all antennas must be performed in a manner that will provide at least 23cm clearance from the front radiating aperture, to any user or member of the public.
  • Page 5 900MHz TC-916 Rev-E 04-2007 SPECIFICATIONS Operating Frequency 915.5MHz +/- 50KHz Modulation AM - Amplitude Modulation Radiated Power TC-916 50mV/m @ 3m TC-916hp 250mW Peak TC-916sp 750mW Peak Range TC-916 Up to 1,000” Line-of-sight TC-916hp Up to 2,000” Line-of-sight TC-916sp Up to 5,700” Line-of-sight...
  • Page 6 900MHz TC-916 Rev-E 04-2007 WARRANTY INFORMATION/ TERMS & CONDITIONS VideoComm Technologies, herein referred to as “VCT.” LIMITED WARRANTY VCT hereby warrants, subject to the conditions here in below, that should this product become defective by reason of improper workmanship or material defect during the specified warranty period, VCT will repair the same, effecting all necessary parts without charge for either parts or labor, or replace the unit at VCT option.

This manual is also suitable for:

Tc-916hpTc-916sp

Table of Contents