Testing The System; Operation; Nightlight Feature - Graco PD191608 Owner's Manual

It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter.
Test the units if you suspect they may have been damaged or have not been used for a long time.
1. If two adults are present, have one take the Parent Units to different locations, trying various volume
settings, while the other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing device near the
Nursery Unit to test it.
3. When testing, keep the level of your child's sounds in mind, and adjust the volume accordingly.
4. If there is sound interference, switch the Nursery Unit and the Parent Units to another channel
setting.
To Listen To Baby
• Turn on Nursery Unit using the ON/OFF button.
• Turn on one or both Parent Units using the ON/OFF button.
• Adjust the volume on the Parent Unit by pressing the Volume Up/Down buttons.
Note the color on sound light LED as the volume button is pressed up or down
to provide a visual feedback for the volume level. The unit will beep louder or softer
depending on the volume level.
• The sound light on the Parent Unit will change color from green to yellow to orange
to red as your child (or other objects) make noise near the Nursery Unit. Please note
that the sound lights and volume control on the Parent Unit are independent of each
other. With the volume turned all the way down, the sound light will still illuminate
and vary in color based on sound intensity as your child (or other objects) make noise
near the Nursery Unit.
• This feature will allow you to locate a misplaced Parent Unit as long as the Parent Unit
is powered on and within range of the Nursery Unit.
• To activate, press the "PF" button on the front of the Nursery Unit (the Nursery Unit
needs to be ON).
• The Parent Unit will generate an audible beep every second and the sound light will flash on and off.
• Once the Parent Unit is located, the audible beep can be shut-off by pressing any button on the Parent
Unit.
1.To turn on the Vibration Alert Feature, press and release the
side of the LCD screen.
2. The icon will display on the LCD.
1.To turn on the NightLight on the Nursery Unit from the Parent Unit press the
NightLight Button. This will put the NightLight on the low setting and you will see
the low symbol .
2. To turn the NightLight on high setting press the NightLight Button one more time
and the high symbol
3. Press NightLight Button again to turn off.
4. The NightLight can be turned on at the Nursery Unit also. Press the NightLight
Button on the top of the Nursery Unit once for low setting, twice for high setting
and a third time to turn it off.
NOTE: When activating the NightLight feature from the Parent Unit, transmission
from the child unit to the parent unit is temporarily disabled.

Testing the System

Operation

Parent Finder Feature
Vibration Alert Feature

NightLight Feature

will show.
button on the left
5