Table of Contents
Advertisement
Quick Links
- Power on/off
- Menu button
- Control keys
- Flip button
LM5 GENERAL IDENTIFICATION
Select once to turn on. Hold down for 2 seconds to power off,
release when "Goodbye" message is displayed.
Also, select at any time to return to beginning of menu functions
"home".
Pages through complete menu options.
The two buttons on the right are used to change any parameter
that appears in the display. In the normal operation mode, these
two buttons will change the desired slope. The slope is limited to
±25.0%.
The slope can quickly be changed from right to left, or front to
back, by pushing the "Flip" button. The numeric value of the
slope does not change, but the direction does. If the display
showed " 20.0%", pushing the "Flip" button will change it to
"20.0% ".
Advertisement
Table of Contents
Related Manuals for Futtura LevelMaster LM5
Summary of Contents for Futtura LevelMaster LM5
- Page 1 LM5 GENERAL IDENTIFICATION - Power on/off Select once to turn on. Hold down for 2 seconds to power off, release when “Goodbye”...
- Page 2 LM5 Overview The LM5 can be operated as a standalone instrument. Complete with 4 alkaline “AA” batteries the LM5 will operate on full power for at least 3 days. The LCD panel back light does go out after 20 seconds when not in use in order to conserve energy. If using the LM5 with an external sensor it must be connected to an external battery.
- Page 3 This screen is required to calibrate the LM5 to the terrain slope Zero Cal .1 your equipment is situated on. This is described further under the calibration part of the manual. 4.1% Next The LM-5 is designed with a fast response time. This fast Fast - - - I - - - - - - Slow response also reflects machine acceleration.
- Page 4 Installation and Calibration The LM-5 has 2 options for calibration. Option 1 is used when the LM5 is being used as a stand- alone unit with no external sensor. Option 2 is to be followed when an external sensor is being used.
- Page 5 3. Weld the bar onto the unit so that both holes are vertical. (The straighter the bar is installed the better). 4. Ensure the correct cable ends are at the control and sensor units. Carefully route the sensor cable so the blade can swivel without stretching the cable. Tie the cable with tie wraps (not included) so that the wire cannot be pinched.
Need help?
Do you have a question about the LevelMaster LM5 and is the answer not in the manual?
Questions and answers
I have the lever master on a road grader and cannot get it calibrated