GT-Lite GT-CB-25A Assembly & Installation

Assembly & Installation: GT-CB-25A | High Lumen 25W/2,500LM LED Bulb
TROUBLESHOOTING GUIDE:
Problem Probable Cause
Bad connection.
Fixture does
not turn on.
Faulty switch.
Power is off.
Discontinue use
Circuit breaker trips
immediately.
or fuse blows when
light is turned on.
CLEANING INSTRUCTIONS:
1. Turn power OFF.
2. Use a soft cloth and a mild, non-abrasive glass cleaner.
3. Lightly wipe and clean the fixture.
DO NOT use solvents.
DO NOT use cleaners containing abrasive ingredients.
NEVER spray cleaning liquid directly onto the LEDs, fixture, or wiring.
- Do not look directly at the LED lights for any length of time.
- Do not shine the light directly into other people's eyes.
This product is guaranteed against failure due to factory defects in
materials or workmanship for one (1) year from the date of purchase.
This warranty is non-transferable and applies only to the original
owner. Proof of purchase required for repair or replacement. This
warranty does not cover normal wear of parts or damage resulting from
any misuse of the product. Misuse of the product includes but is not
limited to: using in extreme weather conditions, opening the housing of
the product, or attempted remodel/alterations made to product.
Solution
Check wiring connections.
Test switch or replace it.
Verify power supply is on.
Call customer service at 1-800-865-6799
Call an electrician.
Complete LED Lighting Solutions
Assembly & Installation: GT-CB-25A | High Lumen 25W/2,500LM LED Bulb
• Lumen: 2500 LM
• Watts: 25W
• Luminous Efficacy: 100
• LED Lifespan: 25,000 Hours
• Color temperature (Kelvin): 5000K
• Operating Voltage: AC120-277V 50/60Hz
• Beam Angle: 360°
7.9"
• CRI: 80
• Base: E26 / Standard Edison Base
• Equivalent: 150W Incandescent
• Damp Rated
• Minimum starting temperature: -10°F (-23°C)
2.76" (Temporary flashing may occur during startup in cold temperatures.)
• Suitable for use in temperatures: -10°F to 104°F (-23°C to 40°C)
• Not suitable for use in enclosed fixtures.
• When using product, basic precautions should always be followed.
• Read and follow these instructions and observe all warnings.
• Carefully read and understand the information given in this manual
before beginning installation. Failure to do so could lead to electric
shock, fire, or other injuries which could be hazardous or even fatal.
• Save these instructions and warnings.
This product may represent a possible shock or fire hazard if improperly
installed or mounted. Products should be installed following these instructions,
local electrical codes, and the current National Electric Code (NEC).
• The use of socket adapters with this product is discouraged.
• NEVER submerge this product in water!
• Do not use in on hot surfaces.
• Do not use in areas near a gas source.
• It is NOT possible to change the LED light source.
• This light is not intended for use in potentially explosive
environments. This is NOT a vapor proof light.
• This work light is NOT A TOY and is not suitable for use by children.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK,
SHUT OFF POWER BEFORE
INSTALLING OR SERVICING THIS FIXTURE