1、Product Introduction 1.1、Introduction Of Product: Thank you for choosing Garwoods 2-in-1 Electric Hob. This product combines with two different calefaction principles. The left zone is infrared cooker and the right zone is induction cooker. It is controlled by the micro-computer touching sensor control system. Please read this operation manual carefully before installing or using this product.
2、Installation Guideline ★ Installation should be followed below requirements: The walls on top of the working face and next to the installation of the electric hob must be heat-proof. The laminated boards and adhesive used for installation must be heat-resistant. For any installation method, the air under the electric hob and behind the cooking range should have enough space for cooling in order to ensure the safety of operating the electric hob.
Page 5
~ In front of the cabinet, open an air inlet with more than 100cm under the location of the electric hob as per illustration II . If the cabinet is not sealed, the air inlet may not be opened so as to ensure heat elimination. illustration II ~ Before put the electric hob into the hole, an water-proof type is properly applied on the bottom of front panel of the electric hob as per...
Page 6
~ Put the electric hob into hole. Insert plug of power line into corresponding socket. The electric hob can be used after power connection as per illustration IV . illustration IV ~ If the electric hob is installed above an oven, fix an insulation part at least 150mm under the electric hob as per illustration V .
4、Operation Method 4.1、Operation Instructions: Power Connection After power connection, buzzer will make a short sound and the electric hob keeps at the stand-by mode. LED digit will show (- - - - ). Usable and Non-usable Place cookware on heating zone (Pls. refer to On switching Cookware ), by pressing the “ON/OFF”...
4.2、Usable and Non-usable Cookware: 1. Please refer to below information to select a suitable cookware cater for all delicious cuisine by the infrared cooker. Most of materials for a flat bottom cookware are suitable for use of the infrared cooker, such as stainless steel pot, iron pot, aluminum pot, ceramic pot and glass pot etc.
4.3、Heating Power Distribution: When two single zones are operating in the same time, the total power level is up to 7. However, the power of one single zone will reduce automatically when the other zone is being cooking so as to maintain the total power level will not exceed 7. Infrared Zone Induction Zone Level...
5、Safety Precautions 5.1 Safety Notes: No other objects then cookware to be placed on the calefaction area. Do not insert any objects like iron wire etc. into the vent in order to prevent any electric shock. Do not put anything to block the air outlet Do not heat up unopened tins of food on the heating zone as pressure will build up in the tin and it can explode, which in turn could result in injury and scalding or damage.
Be sure to remove stains from the bottom of cookware. Otherwise, the stains will be scorched and stuck on the top plate. 7、Product Specification Intelligent 2-in-1 Electric Hob Description EC-2989 Model AC220-240V/50Hz Power Supply Total Rated Power 2800W 750 x 450 x 65 mm...
8、Trouble-shooting Guideline 8.1、Code Of Breakdown: In case of improper installation or use, abnormal power supply or breakdown of the electric hob, the LED digit on front panel will display code of breakdown. Infrared Cooker:- Code of breakdown Root cause of breakdown Failure of heater temperature sensor High power voltage Low Power voltage...
8.2、Trouble Shooting: Garwoods’s electric hob has adopted the most advanced micro-computer inspection and control technology. Some phenomena appeared in the course of working may not indicate problems to occur. Please check the electric hob according to the follow specifications Situation...