Table of Contents
Advertisement
Optical Drive (external)
Inserting an optical disc (cont.)
3. Hold the disc by the edge and face the disc's
printed side up. Push down on both sides of
the disc's center until the disc snaps onto the
hub. The hub should be higher than the
disc when correctly mounted.
NOTE: It is normal to hear as well as feel the CD spinning with great intensity in the
CD drive while data is read.
Removing an optical disc
Eject the tray and gently pry the edge of the disc
upwards at an angle to remove the disc from
the hub.
Using the Notebook PC
4. Slowly push the drive's tray back in. The drive
will begin reading the table of contents (TOC)
on the disc. When the drive stops, the disc is
ready to be used.
Emergency eject
The emergency eject is located in a hole on the op-
tical drive and is used to eject the optical drive tray
in case the electronic eject does not work. Do not
use the emergency eject in place of the electronic
eject. Note: Make sure not to stab the activity
indicator located in the same area.
4
Actual location
will vary by
model�
(continued on next page)
41
Advertisement
Table of Contents
