Metra Electronics Saddle Tramp BC-DSPX-HD1 Installation Instructions Manual

Harley davidson dsp package with water resistant enclosure 1998-2013

INTERFACE COMPONENTS

• BC-DSPX-HD1 circuit board

• BC-DSPX-HD1 harness (with gaskets)

• BC-DSPX-HD1 enclosure

• Case

• Cap (with O-ring)

Metra. The World's Best Kits.

MetraOnline.com

Harley Davidson DSP

Package with Water

1998-2013

Resistant Enclosure

INTERFACE FEATURES

• Water resistant plug-n-play harness for the BC-DSPX-HD1

• BC-DSPX-HD1 included

• Water resistant enclosure with zip-tie mounts included

• Amplifier, if equipped, does not need to be retained

• All wiring will be done at the radio location

• USB Micro-B updatable

BC-DSPX-HD1

I N S T A L L A T I O N I N S T R U C T I O N S

TABLE OF CONTENTS

Connections ............................................................2

Installation ......................................................... 3-4

TOOLS REQUIRED

• Wire cutter

• Crimp tool and connectors

(example: butt-connectors, bell caps, etc.)

• Solder gun, solder, and heat shrink

• Tape

• Zip-ties

ATTENTION: With the key out of the ignition,

disconnect the negative battery terminal

before installing this product. Ensure that all

installation connections are secure before

cycling the ignition to test this product.

NOTE: Refer also to the instructions included

with the aftermarket radio.

REV. 1/13/22 INSTBC-DSPX-HD1

Table of Contents

Need help?

Do you have a question about the Saddle Tramp BC-DSPX-HD1 and is the answer not in the manual?

Page 1 • Case NOTE: Refer also to the instructions included with the aftermarket radio. • Cap (with O-ring) Metra. The World’s Best Kits. ® MetraOnline.com © COPYRIGHT 2022 METRA ELECTRONICS CORPORATION REV. 1/13/22 INSTBC-DSPX-HD1...
Page 2 CONNECTIONS Radio 4ch amp output placement To speakers AXDSPX-WR OE Radio Plug To amp input when Not using DSP High level Imput To amp input Aftermarket Amp 4ch when using DSP Low level Imput 2ch amp placement Optional 2ch amp input BC-9720 Rear Audio Black Bone Harness Added Speakers...
Page 3 INSTALLATION 1. Remove the fairing to access the back of the factory radio. Refer to MetraOnline, part number 99-9600 for fairing disassembly instructions. 2. Install the BC-DSPX-HD1 harness and make all necessary connections, but leave the amp turn-on wire disconnected. 3.
Page 4 INSTALLATION (CONT’D) 7. Download and install the AXDSP-XL App from the Google Play Store or Apple App Store. 8. Open the app and follow the instructions on the Bluetooth Connection tab to pair the mobile device to the BC-DSPX-HD1. (Figure B) 9.
Page 5 REV. 1/13/22 INSTBC-DSPX-HD1...
Page 6 386.257.1187 MetraOnline.com...
Page 7 REV. 1/13/22 INSTBC-DSPX-HD1...
Page 8 Log onto www.installerinstitute.edu or call 386-672-5771 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians Metra. The World’s Best Kits. MetraOnline.com ® © COPYRIGHT 2022 METRA ELECTRONICS CORPORATION REV. 1/13/22 INSTBC-DSPX-HD1...