AEG L7FBE68SC User Manual page 14

Table of Contents

Advertisement

14
www.aeg.com
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
If you touch the Start/Pauza button,
the appliance performs the only
draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
• Pouze vypouštění option (Skipping
the wash, rinse and spin phases) .
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Pouze odstřeďování option (Skipping
the wash and rinse phases) .
The appliance performs only the
spinning phase of the selected
washing programme.
The display shows the indicator
(cold), the phase indicator
spin speed.
If it is necessary to reduce
the spin speed, select a
programme with a lower
spin speed as default.
6.5 Skvrny/Předpírka
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Skvrny
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
will be added in the appropriate
phase of the washing programme.
(no
.
and the
. The stain remover
This option is not
available with a
temperature lower than
40 °C.
• Předpírka
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
The options can increase the
programme duration.
6.6 Pára plus
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric creasing
and facilitates the fabric ironing.
The indicator
flashes on the display
during steam phase.
This option increases the
programme duration
slightly.
When the programme stops the display
shows a zero
, the indicator
steady on and the indicator
flashing. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
button the anti-crease movements stop
and the door unlocks.
A small laundry load helps to
reach better results.
6.7 Odložený start
With this option you can delay the start
of a programme in a more convenient
time.
Touch repeatedly the button to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After touching theStart/Pauza button, the
display shows the indicator
is
starts
and the

Advertisement

Table of Contents
loading

Table of Contents