Honda CSX 06 Manual page 44

Maintenance Minder
General Information (cont'd)
Resetting Maintenance Information Display
NOTE:
• The vehicle must be stopped to reset the display.
• If a required service is done and the display is not
reset, or the maintenance display is reset without
doing the service, the system will not show the
proper maintenance timing. This can lead to serious
mechanical problems because there will be no
accurate record of when the required maintenance is
needed.
• The engine oil life and the maintenance item(s) can
be only reset independently with the HDS.
1. Turn the ignition switch to ON (II).
2. Push and release the SEL/RESET button repeatedly
until the engine oil life indicator is displayed.
3. Press and hold the SEL/RESET button for about 10
seconds. The engine oil life indicator and the
maintenance item code(s) will blink, then release
the button.
NOTE: If you are resetting the display when the
engine oil life is more than 15 %, make sure the
maintenance item(s) requiring service are done
before resetting the display.
4. Press and hold the SEL/RESET button for another
5 seconds. The maintenance item code(s) will
disappear, and the engine oil life will reset to ''100''.
3-6
Resetting Individual Maintenance Items
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2 on page 11-3).
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle
and the engine control module/powertrain control
module (ECM/PCM). If it doesn't communicate,
troubleshoot the DLC circuit (see page 11-6).
4. Select GAUGES in the BODY ELECTRICAL with the
HDS.
5. Select ADJUSTMENT in the GAUGES with the HDS.
6. Select SERVICE REMINDER in the ADJUSTMENT
with the HDS.
7. Select RESET in the SERVICE REMINDER with the
HDS.
8. Select the individual maintenance item you wish to
reset.