Panasonic TC-P42C1 Operating Instructions Manual page 48

Technical Information
Aspect Ratio: 4:3
Size 1
Aspect Ratio: FULL/JUST(H-FILL/ZOOM)
Size 1
See pages 26-27 for more information
Do not display a picture in 4:3 mode for an extended period, as this can cause
"Image retention" to remain on either or both sides of the display field.
To reduce the risk of such "Image retention", change the brightness of the side
bars.
See pages 28-29 for more information
The side bar may flash (alternate black/white) depending on the picture. Using
Cinema mode will reduce such flashing (See below).
Scrolling bar: To prevent "Image retention", scrolls white vertical bar from left to right on a black screen.
Press any key except the POWER key to return to previous screen.
You will return to the previous screen if no key operation has been performed for 15 minutes.
See pages 28-29 for more information
* Mark: Applicable input signal for Component (Y, P
525 (480) / 60i
525 (480) /60p
750 (720) /60p
1,125 (1,080) /60i
1,125 (1,080)/60p
1,125 (1,080)/60p
1,125(1,080)/24p
1,125(1,080)/24p
Note
Signals other than those shown above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
48
H size
The width will be decreased on both sides to
Size 2
reduce noise.
The width will be increased on both sides to
Size 2
reduce noise.
4:3 side bars
Scrolling bar
Input signals that can be displayed
, P ) and HDMI
B R
horizontal
frequency (kHz)
15.73
31.47
45.00
33.75
67.43
67.50
26.97
27.00
Side Bar
Screen
Display
vertical
COMPONENT
frequency (Hz)
59.94
59.94
59.94
59.94
59.94
60.00
23.98
24.00
(Continued)
Image retention
4:3
[Scrolling bar]
HDMI
* *
* *
* *
* *
*
*
*
*