Basic Operation; Hardware Design - Ebyte E32 Series User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
14 DIO3
15 DIO4
16 DIO5
17 GND
18 GND
19 DIO1
20 DIO0
21 NRST
22 MISO
23 MOSI
24 SCLK
25 NSS
26 GND
27 ANT
28 GND

4 Basic operation

4.1 Hardware design

It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible and

the module needs to be reliably grounded;
Please pay attention to the correct connection of the positive and negative poles of the power supply,

reverse connection may cause permanent damage to the module;
Please check the power supply to ensure that between the recommended supply voltage, if exceeding the maximum,

the module will be permanently damaged;
Please check the stability of the power supply. Voltage can not fluctuate greatly and frequently;

When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of the

margin, so the whole machine is beneficial for long-term stable operation;
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and

other parts with large electromagnetic interference;
Bottom Layer High-frequency digital routing, high-frequency analog routing, and power routing must be avoided

under the module. If it is necessary to pass through the module, assume that the module is soldered to the Top Layer,
and the copper is spread on the Top Layer of the module contact part(well grounded), it must be close to the digital
part of the module and routed in the Bottom Layer;
Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom

Layer or other layers, which will affect the module's spurs and receiving sensitivity to varying degrees;
It is assumed that there are devices with large electromagnetic interference around the module that will greatly

affect the performance. It is recommended to keep them away from the module according to the strength of the
interference. If necessary, appropriate isolation and shielding can be done;
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
Input/Output General IO port (see SX1278 manual for details)
Input/Output General IO port (see SX1278 manual for details)
Input/Output General IO port (see SX1278 manual for details)
Ground
-
Ground
-
Input/Output General IO port (see SX1278 manual for details)
Input/Output General IO port (see SX1278 manual for details)
Input Chip reset trigger input pin
Output SPI data output pin
Input SPI data output pin
Input SPI data output pin
Input the module chip selects the pin used to start an SPI communication
Ground
-
Antenna interface, Sample hole (50Ω characteristic impedance)
-
Ground
-
E32-400M30SA User Manual
7