Table of Contents
Advertisement
Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
7 Removal and installation / 7.3 Installing the turbocharger
7.3 Installing the turbocharger
© Copyright 2020 . All rights reserved.
WARNING
Beware of tilting
If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Wear personal protective equipment (PPE).
u
Support the turbocharger at a suitable point.
u
Secure with lifting gear wherever possible.
u
Cover the oil connection.
u
Remove cover from oil connection.
u
Inspect lifting gear.
u
Fasten separate lifting gear to each of two bearing casing ribs
u
provided for this purpose.
CAUTION
Oil orifices
There is an orifice for adjusting the oil pressure in each of the two oil
supply pipes of the bearing casing. When the cartridge group, the bear-
ing casing or the turbocharger-is being fitted to the engine, it must be
ensured that the orifices specified for the turbocharger are installed in
both oil supply pipes.
Check that the oil orifices have been correctly installed.
u
Adapt turbocharger to suit engine.
u
Tighten fixing screws in foot in accordance with engine builder's in-
u
structions.
Fasten gas, air and oil lines in accordance with engine builder's in-
u
structions.
TPL65: Version with compressor wheel cooling system
Fit air supply line. (See also chapter Preliminary remarks / Layout and
u
functioning.)
Refit removed parts of insulation.
u
Plug in cable connector on speed sensor.
u
HZTL2498_EN
Rev.F
December 2020
Advertisement
Table of Contents
