Table of Contents
Advertisement
Sensors
en
Programme end
End appears on the display panel and the
Start/Reload button indicator lamp is off.
If the 9 symbol appears on the display
panel, the washing machine has detected
too much foam during the wash
programme and automatically switched on
a rinse cycle to remove the foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Set the programme selector to Off.
2.
The appliance is switched off.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door and
■
detergent drawer open so that any
residual water can dry away.
Always wait for the end of the
■
programme, otherwise the appliance
may still be locked. Then switch on the
appliance and wait for it to unlock.
If the display panel goes off at the end
■
of a programme, energy-saving mode
is active. To activate the panel, press
any button.
20
H
Sensors
A utomatic load sensing
S e n s o r s
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum. ~ Page 26
VoltCheck
The automatic voltage control system
detects that the voltage has fallen to an
impermissible value. The colon in the
"Ready in" display flashes on the display
panel. ~ Page 9
If the supply voltage is stable again, the
colon in the "Ready in" display will stop
flashing.
However, if the fall in voltage causes the
programme to be extended, the dot
flashes in the "Ready in" display.
Advertisement
Table of Contents
