hq telecom HQ-TS-350 Step-By-Step Instructions

Step-by Step Instructions for the Installation and Programming for the
Outgoing Phone Blocker with Allow & Disallow Memory
UPDATES & SAFETY INSTRUCTIONS:
Please refer to hqtelecom.com
phone blocker (also
Manual.pdf).
INSTALLATION: Please connect the Call Blocker as shown in the diagram below:
PROGRAMING:
After installing it, lift off the handset connected to the PHONE port of the device and use the
dial-pad to program your device as shown below.
To DISALLOW numbers,
area codes, and prefixes:
#0* (wait to hear beep)
05 (beep)
Enter Disallow-number
## (2 beeps)
hangup
To ALLOW numbers,
area codes, and prefixes.
#0* (beep)
08 (beep)
Enter Allow-number
## (2 beeps) hang-up
for latest updates and safety instructions about this outgoing
http://hqtelecom.com/PhoneBlocker-wAllow-and-Disallow-Memory-
Examples:
- Block all 10-digit calls starting with area code 305-xxx-xxxx:
#0* (beep) 05
Note: You need to enter * 7 times as a wild card. If you are
required to dial 1+area code + number, you will need to enter
1305******* ##.
- Block all 10-digit calls starting with prefix 305-558-xxxx:
#0* (beep) 05
Note: You need to enter * 4 times as a wild card for each digit.
1305558**** ##.
IMPORTANT:
HEAR FROM YOUR PHONE COMPANY WHILE PROGRAMMING
THIS DEVICE.
By default all numbers are allowed. So, if you want to
program this device to only ALLOW certain numbers (prefixes
or area codes), you first need to DISALLOW it (using function
code 05 as shown above).
For example, you can DISALLOW all calls starting with 305
(using the 05 function code as shown above). Then use
(beep) 305******* ##
(beep) 305558**** ##
PLEASE IGNORE ALL ERROR MESSAGES YOU
(beep, beep)
(beep, beep)