Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Valen ENLiFEN
- Page 1 VALEN ENLiFEN LITHIUM INSTALLATION AND OPERATING INSTRUCTIONS TO BE INSTALLED BY A SUITABLY QUALIFIED ELECTRICIAN ONLY AUSTRALIA NEW ZEALAND 1300 734 253 0800 734 253 sales@valen.com.au sales@valen.co.nz www.valen.com.au www.valen.co.nz VERSION 1 APRIL 2021...
-
Page 2: General Information
Section 1 General Information Valen ENLiFEN PO4 Lithium Phosphate batteries are only to be used in conjunction with the below. Please ensure all instructions are read prior to battery use and warnings are adhered to during the installation and operation of these batteries. The lithium (LiFePO4) battery cells and modern digital embedded, computerised technologies culminate in an energy storage solution that has many unique advantages. -
Page 3: Receipt Of Equipment
INDUSTRIAL BATTERY & ENERGY STORAGE SOLUTION PROVIDER and equipment. Read this manual thoroughly before attempting to install the battery. If there are any questions about safety, contact VALEN before installing the batteries. Tips: • Using the battery correctly along with the below tips will extend the batteries life and prevent it from premature failure. -
Page 4: General Installation Procedures
(not float charging) condition. If the storage temperature is 5°C to 30°C, VALEN ENLiFEN LiFePO4 Batteries must be charged at least every 6 months while in storage. If stored at ambient temperatures above 30°C, charge the batteries every 4 months. - Page 5 If the VALEN ENLiFEN Batteries are installed in a client’s own enclosure, it should be designed to allow unobstructed air circulation and prevent temperature build-up. Sufficient air circulation should be present to prevent temperature-layering effects.
- Page 6 Ensure that sufficient space is available for handling and placement of the modules. Do not place the VALEN ENLiFEN Batteries near a source of heat, in direct sunlight or where the module may be subject to condensation or water spray. When connected, check the battery voltage. Check the cell voltages and record them with the module ID.
-
Page 7: Operation
Visually check that all connections are properly made (positive to negative) and are tight. Measure module voltage, check that this is between 11.8V-13.8V. CAUTION! High voltage may be present. If the voltage of a module is not between these values, contact your VALEN representative for further instructions. 4.5.5 Battery to Charger Connection Ensure that the charger is disconnected from the power line. -
Page 8: Maintenance & Record
General maintenance of the battery means keeping the battery and surrounding area clean and dry. Since VALEN ENLiFEN Batteries are of low maintenance design, there is no addition of water or specific gravity checks needed for the life of the battery. -
Page 9: Capacity Testing
3. Determine the battery temperature by measuring and recording the temperature of every 15 blocs. For further technical support, please contact VALEN on the below details. AUS 1300 734 253 NZ 0800 734 253... - Page 10 Company Details Legal Entity Valen Power Pty Ltd 134 028 961 Telephone 1300 734 253 AUSTRALIA NEW ZEALAND 1300 734 253 0800 734 253 sales@valen.com.au sales@valen.co.nz www.valen.com.au www.valen.co.nz...
Need help?
Do you have a question about the ENLiFEN and is the answer not in the manual?
Questions and answers