HOME PAGE Figure 1 (Lighting Section) This section allows you to have quick control over frequently used lights in the coach. ▪ Figure 2 (Climate Section) This section displays climate information and current heating, cooling, and fan status. Press on this ▪...
This section displays your current page. ▪ 2. Active Fault Icon If this Icon is present a fault has occurred in the Spyder system. Press it to jump to the fault page. ▪ 3. Home Icon When pressed the screen will return to the home page.
LIGHTING PAGE Figure 1 (Main) This section allows control over your main interior lights. Any lights that ▪ can dim will contain two arrows beside the light. Holding this light button will bring up a dimming slider. Drag the slider up and down to set the desired brightness level.
CLIMATE PAGE Figure 1 (Zone + Ambient Temperature) This section displays the location of the air-conditioning unit and the ambient temperature in the ▪ zone. Figure 2 (HVAC Mode Select) This section provides control over your HVAC loads. Press an icon to activate it. For safety and the ▪...
Page 8
Climate Page Continued Figure 4 (Fan Control) This section allows control of the AC fan. When you run the AC in cooling mode you will be able to ▪ select either Fan High, Fan Low, or Auto. Auto mode will control the fan for you choosing the best time to switch from High to Low.
SLIDE PAGE Figure 1 (Slide Extend/Retract) Pressing these buttons will extend and retract your slides if the requirements shown in Fig.2/3 are ▪ met. Figure 2 (Slide Run Warning) This warning will appear when you try to run your slides if one or more of the following conditions ▪...
MECHANICAL PAGE Figure 1 (Fan On / Off) Press this to toggle the selected fan on and off. ▪ Figure 2 (Ceiling Fan Control) This button allows control of the ceiling fan (if applicable). Press the corresponding buttons to ▪ select fan speed.
FAULT PAGE Figure 1 (Active Fault List) This list will show any active fault in the coach, if a fault appears here please contact Spyder ▪ Controls for trouble shooting. Press the tech support button to view Spyder Controls support information.
▪ troubleshooting) Figure 4 (GUI Version) This shows the version of your screens program, Spyder may ask for this during service ▪ Figure 5 (Wireless Settings) Press here to access Wireless Switch Settings. Your coach may not be equipped with Wireless ▪...
On diagnostic pages a green dot indicates the load is on while grey indicates a load is off ▪ Load – Any electrical device controlled by the Spyder Multi plex System (i.e. Bathroom Lights, Air conditioner compressor, Water Pump, etc) Constant Loads –...
DIAGNOSTIC LED FEATURES NET LED Functions The NET LED (Network LED) is used to identify the network status of a module (i.e. Switch panel, G6 House Panel pictured here). NET LED’s are useful for trouble shooting and identifying and issue with a coach.
G6 Panel. RSI-9 TROUBLE SHOOTING When getting support from Spyder Controls you may be asked to locate the RSI-9 Module. The enlarged card above is the RSI-9. For convenience common areas of interest have been labeled.
SUPPORT If you have any questions or concerns about your Spyder Controls Multiplex System please contact Spyder Controls toll free at (866) 919-9092 or reach us by email at info@spydercontrols.com. For service manuals and helpful videos on your coach please visit Spydercontrols.com press “login” then...
Need help?
Do you have a question about the 2021 ALLEGRO RED and is the answer not in the manual?
Questions and answers