AEG S71440TSW0 User Manual page 32

32 www.aeg.com
9.3 Location
9.4 Installing under a continuous worktop
200 cm
93-103 mm
100 mm
15 mm
A
2
105 mm
570 mm
550 mm
min. 820 mm
500/550/600 mm
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet.To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the mini-
mum distance between the top of the cab-
inet and the wall unit must be at least 100
mm . Ideally, however, the appliance
should not be positioned below overhang-
15 mm ing wall units. Accurate levelling is ensured
by one or more adjustable feet at the base
of the cabinet. If the cabinet is placed in a
corner and the side with the hinges facing
the wall, the distance between the wall
and the cabinet must be at least 10 mm to
allow the door to open enough so that the
shelves can be removed.
WARNING!
It must be possible to disconnect
the appliance from the mains pow-
er supply; the plug must therefore
be easily accessible after installa-
tion.
If your refrigerator is installed under a
continuous worktop, an air outlet open-
ing of at least 200cm
grille matching the worktop design
should be installed at the rear of the
worktop.
The cut surfaces of the worktop should
be varnished to avoid swelling due to
penetration of moisture.
The appliance wall distance must be at
least 30 mm and should be checked be-
fore the ventilation grille is inserted.
2
and a ventilation