1. Manuals
  2. Brands
  3. DEVAISE Manuals
  4. Massager
  5. AZZY002
  6. Manual

DEVAISE AZZY002 Manual

Pu single motor power lift recliner
Hide thumbs

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AZZY002 and is the answer not in the manual?

Questions and answers

Summary of Contents for DEVAISE AZZY002

  • Page 2: Safety Rules

    Safety Rules Never set the lift chair in wet / damp areas or where dust can accumulate because these could cause an electrical fault or a mechanical dysfunction. Never use the lift chair inside your home if the room temperature is over 120°F.

  • Page 3: Problems And Solutions

    Problems and solutions The lift chair does not function when the button on the control unit is activated. Check that the plug is pushed into the wall oultlet properly. Check whether the power supply button is on. Can't massage or heat. Power cord problem, please make sure the indicator lit.

  • Page 4: Assembly Parts

    If you have any further questions, please feel free to contact us by email or official website: devaise-cs@devaise.com We will reply ASAP. Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponging to the list, and the quantity is correct.
  • Page 5 REMARK You need to cut the white strapping cable off and take all the accessorries out before installation. 1. Position the armsrests Put the armrests fit into the seat, you will hear a "click" when they are in place.
  • Page 6 2. Position the backrest Put the back fits into the seat, you will hear a "click" when it is in place.
  • Page 7 If you need to disassemble after installation, please disassemble the backrest before pulling out the armrests on both sides. REMARK When removing the backrest, please pull the iron sheets up hard.
  • Page 8 4. Connect the supply cable pins REMARK No.1 and No.2 wires on Part A connect with No.1 and No.2 wires on Part B . No.3 wire connects with part E . No.4 wire connects with part D .
  • Page 9 5. Connect the supply cable pins Lock Push Warning! The pins must be connected correctly. If the lift chair doesn't work when you finally turn it on, it is because the pins have been connected incorrectly. If that should happen, turn the power off and reconnect the pins.
  • Page 10 Instruction of Remote Control How to use massage remote control? POWER: Turn on / off massage remote control. POWER HEAT INTENSITY HIGH HEAT: Turn on / off heat function for lumbar part only. PULSE PRESS MODE WAVE INTENSITY: Adjust the strength of the massage according AUTO NORMAL BACK...

Table of Contents