Table of Contents
Advertisement
Subject in recorded image is too dark.
Insufficient light for
shooting.
The subject is
underexposed because
the surroundings are too
bright.
Subject is too far away
for flash to reach.
Subject in recorded image is too bright, or
image flashes white.
Subject is too close,
making the flash too
strong.
The subject is
overexposed because
the surroundings are too
dark.
Too much light is shining
directly into the camera,
or is being reflected off
the subject.
Flash is set to on.
Image contains noise.
ISO speed is too high.
Set the flash to
Guide p. 14).
Set the exposure compensation to a
positive (+) setting (p. 52).
Use AE lock or use the spot metering
function (pp. 49, 51).
Shoot within correct shooting
distance of the subject when using
the built-in flash (p. 130).
Raise the ISO speed and then shoot
(p. 65).
Shoot within correct shooting
distance of the subject when using
the built-in flash (p. 130).
Set the exposure compensation to a
negative (-) setting (p. 52).
Use AE lock or use the spot metering
function (pp. 49, 51).
Change the shooting angle.
Set the flash to
Guide p. 14).
Higher ISO speeds and the
ISO Auto) setting may increase image
noise. For higher image quality, select
as low an ISO speed as possible (p.
65).
In
,
,
,
modes, the ISO speed increases and
noise can appear.
(flash on) (Basic
(flash off) (Basic
(High
,
,
and
111
Advertisement
Table of Contents
