Connecting The Water Inlet Hose - LG T2350VSPM Owner's Manual

Connecting the Water Inlet
Hose
Before connecting the water inlet hose to the water
tap, check the hose fitting type and then choose
the correct instruction.
Note for Connection
• Water supply pressure must be between 30
kPa and 800 kPa (0.3 - 8.0 kgf / cm²). If the
water supply pressure is more than 800 kPa, a
decompression device should be installed.
• Do not overtighten the water inlet hose to the
valve.
• Periodically check the condition of the hose
and replace the hose if necessary.
Checking the Rubber Seal
Two rubber seals a are supplied with the water
inlet hoses. They are used to prevent water leaks.
Make sure the connection to taps should be
sufficiently tight.
Connecting the Hose to the Water
Tap
Connecting One Touch Type Hose to Tap
Without Thread
1
Unscrew the adapter ring plate b and loose
the 4 fixing screws.
2
Remove the guide plate c if the tap is too
large to fit the adapter.
3
Push the adapter onto the end of the tap
so that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate d down, push
the inlet hose onto the adapter, and release
the connector latch plate. Make sure the
adapter locks into place.
EN
4
13