Asus PRIME H310M-D R2.0 Manual page 10

ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
•
•
•
•
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan
of maximum 0.5A (6 W) fan power.
Intel ® LGA1151 CPU socket
Install Intel
designed for 8th Generation Intel
processors.
For more details, refer to Central Processing Unit (CPU).
M.2 socket 3
This socket allows you to install an M.2 (NGFF) SSD
module.
•
•
•
1-2
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12V Specification 2.0 (or later version) and provides
a minimum power of 350 W. This PSU type has 24-pin and 4-pin power plugs.
DO NOT forget to connect the 4-pin ATX +12V power plug. Otherwise,the system
will not boot up.
We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.
asus.com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for
details.
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
This M.2 socket supports M Key and 2242/2260/2280
storage devices.
When a device in SATA mode is installed on the M.2
socket, SATA_2 port cannot be used.
Due to the Chipset limitation, when an M.2 device is
installed in PCIe mode, the socket is set to PCIe 2.0.
Core™ i7 / i5 / i3, Pentium
®
Chapter 1: Product introduction
, and Celeron
® ®
M.2(SOCKET3)