Laser CASE-2S3 Quick Start Manual

PRODUCT CONNECTIONS AND USE
1. Remove the end of the HDD case
containing the USB3.0 cable socket
(here on referred to as the "header")
Note: Ensure any fastening screws have
been removed from the header
2. Gently connect the header to your HDD,
being careful not to touch any of the
electronic connection surfaces
3. Slide the HDD and header back into
the case. This should require little to
no force.
4. Once the header and HDD have seated
correctly into the case housing, screw
the fastening screws into the side
of the unit.
FEATURES AND OPERATION
Hardware requirement
USB3.0 port (or PCIE/Express USB3.0 Card with USB3.0 port)
Operation system
Windows 2000 /XP /Vista /Win7
System Requirement
Operation system: Windows XP /Vista /Win7
Features
Suitable for 2.5" SATA HDD
USB3.0 to SATA interface
Transfer rate max up to 5Gb/s
Backwards compatibility with USB 2.0 (480Mbps)
Plug & Play supported
Power supply via Motherboard Bus power
For further product information and instruction please visit our product web page at
www.laserco.net
Please note: As continual improvements are made to this product, slight operational differences
may occur. For the most up-to-date user manual, please visit our web site.
CASE-2S3
or email support@laserco.com.au
QUICK START GUIDE
1