Table of Contents
Advertisement
Quick Links
SED-VTI
April 2020, V1.2
Virtual Telephone Interface
Installation & User Manual
WARNING: PLEASE READ
INSTALLATION INSTRUCTIONS
FIRST
PRODUCT WARRANTY
This product is covered by a 12 month, back to base warranty from
date of purchase and proof of purchase should be supplied. The
warranty does not cover damage that has resulted from the
improper installation or improper use of this product. The warranty
does not cover lightning damage, product misuse, electrical surges
or acts of God.
LIMITATION OF LIABILITY
Sec-Eng Systems Pty Ltd does not accept any liability for the loss
or damage to property or persons in relation to goods supplied.
This disclaimer is only limited to the warranty of the goods supplied
and the intended use.
©
NOTE: THIS MANUAL IS SUBJECT TO COPYRIGHT
Advertisement
Table of Contents
Related Manuals for SecEng SED-VTI
Summary of Contents for SecEng SED-VTI
- Page 1 SED-VTI April 2020, V1.2 Virtual Telephone Interface Installation & User Manual WARNING: PLEASE READ INSTALLATION INSTRUCTIONS FIRST PRODUCT WARRANTY This product is covered by a 12 month, back to base warranty from date of purchase and proof of purchase should be supplied. The warranty does not cover damage that has resulted from the improper installation or improper use of this product.
- Page 2 CHECKING SIM CARD OPERATION The unit requires a MICRO size SIM card to operate. Before fitting into the SED-VTI ensure that the SIM is active and not pin locked. This may require the SIM to be tested in a mobile phone first.
- Page 3 TESTING 1. Plug a test telephone into the RJ connector of the SED-VTI and ensure you can make a phone call (dial the receiver number). 2. Remove the test phone and connect the panel to the RJ port.
- Page 4 LEDS & FAULT GUIDE LED INDICATION Signal strength FAULT System fault Hook indicator Power status FAULT Modem on indicator FAULT GUIDE FAULT ON = System/connection issue ON = Line off hook ON (steady) = System ready Flashing = Power in is low FAULT If FAULT LED is flashing, check for the following: •...
- Page 5 This can be set with the command: button delay xx (xx is time in seconds) Call timer – Set the maximum duration for a call. As time expires the SED-VTI will force the call to end.
- Page 6 (Australia), Vodafone (All Vodafone networks), Telecom NZ, Rogers, Bell Mobility, Telus (Canada), SKT (S. Korea), ICASA (S. Africa), AT&T (US). ACMA - RCM Certified TECHNICAL SUPPORT Contact Sec-Eng Systems for technical support Phone 02-9524 9952 Mon – Fri 9.00AM to 5.00PM AEST WWW.SECENG.COM.AU...
Need help?
Do you have a question about the SED-VTI and is the answer not in the manual?
Questions and answers