Table of Contents
Advertisement
SPECIFICATIONS
Long Term Storage (Over 30 Days)
Do not store your unit for a prolonged period of time (30 days or longer)
without performing protective storage maintenance which includes the
following:
1.
Store unit in a dry, dust free place, out of the reach of children.
2.
Place the stop switch in the "STOP" position.
3.
Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
4.
Perform all periodic lubrication and services that are required.
5.
Apply clean oil to the entire length of the blade. Be certain the blade
bolts are lubricated.
6.
Install blade cover on blades.
7.
Tighten all the screws and nuts.
8.
Drain fuel tank completely. Press purge bulb 6-7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
9.
Allow engine to cool. Remove the spark plug lead from the spark plug.
Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug hole.
a.
Place a clean cloth over the spark plug hole.
b.
Pull the recoil starter handle 2-3 times to distribute the oil inside the
engine.
c.
Observe the piston location through the spark plug hole. Pull the
recoil handle slowly until the piston reaches the top of its travel and
leave it there.
10. Install the spark plug. Connect the spark plug lead to the spark plug.
SPECIFICATIONS
MODEL
Length
Width
Height
Weight (dry)
Engine Type
Bore
Stroke
40
SHC-2620
2,243 mm (88.3 in.)
5.9 kg (13.0 lb.)
Air cooled, two-stroke, single cylinder gasoline engine
SHC-2620S
2,027 mm (79.8 in)
273 mm (10.7 in.)
260 mm (10.2 in.)
5.7 kg (12.7 lb)
34.0 mm (1.34 in.)
28.0 mm (1.10 in.)
© 07/19 ECHO Incorporated
SHC-2620 / S
X7502342003
Advertisement
Table of Contents
