Advertisement
After the position of the projector and screen installation has been determined, tear off the
protective paper from the grommet holder, attach the holder to the front foot, then paste to the
tabletop.
*Ensure that the grommet holder fits in place with the outer contour of the front foot.
Pull out the lifting bracket beside the rear foot, then push it onto the wall surface. Mark the
position on the wall surface, tighten the screws again, then note the relative position between the
projector and the wall.
Repositioning the Projector
3.
Step 1: Check whether the foot is stuck on the inlay of the grommet holder. If the foot is not stuck,
realign the front foot with the position of the grommet holder.
Step 2: Pull out the lifting bracket beside the rear foot and check whether it is directly positioned
on the marked area of the wall. If the bracket is off, the relative position with the wall has changed.
Adjust until the lifting bracket exactly hits the marked area on the wall, indicating that the relative
position has been corrected.
Grommet Holder
Lifting Bracket
六. After-Sales Service
Shenzhen Holatek Co., Ltd. (hereinafter "JMGO") formulates its after-sales policies in strict
accordance with relevant laws and regulations to provide the "three guarantees" of repair,
replacement, and return.
1. Warranty Policy
Service Period:
1)
European Region
a)
Policy（维维帮忙核对售后部分）
Advertisement
