Advertisement
DOG TRAINING COLLAR WITH GPS TRACKER
MODELS: GPS-DTR 25000-25002-25003 (GPS and Training Function)
GPS 25000-25002-25003 (No Training Function)
PRODUCT INCLUDES:
Collar, USB Charger, USB Cable, Adapter
Remote Control and antenna, long/short probes if trainer
PREPARING THE GPS-TRAINING COLLAR FOR FIRST USE
Charge the collar for 7-8 hours. The battery has a standby time of 20 hours when fully charged. Connect the
small USB adapter to the USB cable, and then the cable to the USB charger. Then connect the charger to the
collar as shown on the picture below. Lift the orange plastic protective cover and connect the charger. Now
switch on the collar. To switch it on, hold for 1 second the back side of the remote control at the USB output
(where the built-in magnet is), at the point where the collar indicator led is. Then remove the remote control.
The red indicator led of the collar will continuously light showing that the device is charging. In order to
complete a full charge you need to switch off the collar with the remote control magnet.
After 7-8 hours of charging, remove the charger. To switch off the collar, hold for 4 seconds the remote
control part (where the built-in magnet is) at the point where the collar indicator led is.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hunter GPS-DTR 25000
Summary of Contents for Hunter GPS-DTR 25000
- Page 1 DOG TRAINING COLLAR WITH GPS TRACKER MODELS: GPS-DTR 25000-25002-25003 (GPS and Training Function) GPS 25000-25002-25003 (No Training Function) PRODUCT INCLUDES: Collar, USB Charger, USB Cable, Adapter Remote Control and antenna, long/short probes if trainer PREPARING THE GPS-TRAINING COLLAR FOR FIRST USE Charge the collar for 7-8 hours.
- Page 2 The remote control should be charged for 4-5 hours. Connect the charger to the remote control USB connector on the top. PAIRING AND USE THE GPS-TRAINING COLLAR The collar you purchased is already paired with the remote control. If you want to pair it again, follow the instructions below.
- Page 3 GPS TRACKER The collar has a build-in GPS antenna and the remote control a Bluetooth module. The remote control communicates with the mobile phone or tablet via Bluetooth. The mobile phone or tablet must be Android 4.4 or later version and Bluetooth version 4 or 5. To synchronize the remote with your mobile, follow these steps: 1.
Need help?
Do you have a question about the GPS-DTR 25000 and is the answer not in the manual?
Questions and answers
Minhas coleiras parou de pegar não aparece mais as cabeças de cachorro no celular o que faço para funcionar de novo